Day: November 18, 2021

To obtain Huawei H12-211 certification, you must learn to prepare for the examTo obtain Huawei H12-211 certification, you must learn to prepare for the exam

To obtain a Huawei-certified HCIA-Routing and Switching V2.5 H12-211 exam, you must be ready for the exam. The most important thing is the H12-211 exam dumps materials! But so many resources provide strange content in actual exams or don’t prepare us in a meaningful way. Therefore, Pass4itSure is different. Pass4itSure eliminates the problem and provides meaningful test preparation.

Huawei H12-211

Pass4itSure H12-211 exam dumps (Link https://www.pass4itsure.com/h12-211.html PDF + VCE) provide real-world questions about simulated test sites and worksites to help you acquire the core skills and key competencies you need for Huawei certification and future careers.

Huawei HCIA-Routing & Switching V2.5 H12-211 PDF free download

Take advantage of this once-in-a-lifetime opportunity today. This is part of the real H12-211 exam question. After that, you must also devote enough time to complete your studies before you can pass.

HCIA-Routing & Switching V2.5 H12-211 exam PDF https://drive.google.com/file/d/1ysUrA1VqHGzfCgohB1hd_hq9U4aNdhPf/view?usp=sharing

Share some Huawei H12-211 exam questions and answers below:

QUESTION 1 #


Which of the following forms of DUID can be configured when DHCPv6 is configured in the VRP system? (multiple
choice)

A. DUID-LL
B. DUID-LLT
C. DUID-EN
D. DUID-LLC

Correct Answer: AB

QUESTION 2 #

The STP switch sends BPDUs. The correct statement about BPDU is (). (multiple choice)

A. BPDU is a frame using the IEEE802.3 standard
B. BPDU is a frame using the Ethernet II standard
C. The Control field value of the BPDU frame is 3
D. The destination MAC address of the BPDU frame is the broadcast address

Correct Answer: AC

QUESTION 3 #

What benefits does port aggregation yield? (Choose three)

A. Improves link bandwidth
B. Implements load sharing
C. Improves network reliability
D. Facilitates data copy for analysis

Correct Answer: ABC

QUESTION 4 #

A layer 2 LAN switch generates CAM table entries according to the ( ) of the received frame.

A. Source MAC address
B. Destination MAC address
C. Source IP address
D. Destination IP address

Correct Answer: A

QUESTION 5 #

The network administrator wishes to transmit data between two end stations. The network interface cards of both
devices operate at 100Mbps however one supports half-duplex while the other uses full-duplex
mode.

What will occur as a result?

A. The end stations cannot communicate.
B. The end stations can communicate, but data may be lost during the transmission of large amounts of traffic.
C. The end stations will operate normally
D. The end stations can communicate, but speed is different during the transmission of large amounts of traffic

Correct Answer: B

QUESTION 6 #

InARP resolves the protocol address of the remote device on each virtual circuit, including IP addresses and IPX
addresses.

A. True
B. False

Correct Answer: A

QUESTION 7 #

Which of the following are routing protocols? (multiple choice)

A. IP
B. OSPF
C. BGP
D. IPX

Correct Answer: BC

QUESTION 8 #

Which of the following port status may exist on an STP-enabled switch?

A. Forwarding
B. Listening
C. Discarding
D. Disabled

Correct Answer: AB

QUESTION 9 #

As shown in the figure, after the network administrator finishes the Telnet configuration on the router, it finds that the host cannot establish a connection with the router through Telnet. Which options can help solve this problem? (multiple choice)

A. Check if the host\’s ARP cache table overflows
B. Check if the switch is configured with the default gateway address.
C. Use ping to check the IP connectivity between the host and router G0/0/0 interface
D. Check if the Telnet configuration on the router is correct.

Correct Answer: CD

QUESTION 10 #

Which of the following protocols can be used on a Layer 2 network with redundant links to prevent loops?

A. UDP
B. VRRP
C. STP
D. ARP

Correct Answer: C

QUESTION 11 #

Refer to the debug output. Following the configuration of R2, the administrator discovers that the behavior is not as
expected and performs debugging. Based on the output from the debug, what is the source of the problem?

A. R2 has configured an ACL to block the route to network 1.0.0.0
B. R2 has enabled split horizon.
C. R1 is using authentication, however, R2 is not.
D. R2 is operating using RIPv2, while R1 is using RIPv1.

Correct Answer: D

QUESTION 12 #

Which of the following regarding Frame Relay DLCI is correct? (Choose three)

A. DLCI is locally significant
B. DLCI is allocated by DTE
C. The range of DLCI values that can be used is from 16-1007
D. The same DLCI can be configured on different physical interfaces

Correct Answer: ACD

QUESTION 13 #

SNMP packets are encapsulated in TCP packets.

A. True
B. False

Correct Answer: B

The help of free H12-211exercise questions is also great, adding a point to your exam success. If you feel good, you can go get full at Pass4itSure.

Exam preparation H12-211 dumps created and planned by the leader of Pass4itSure https://www.pass4itsure.com/h12-211.html (H12-211 Q&As summary: 714).

The ultimate success in the Huawei H12-211 exam is no longer a dream.

Pass4itSure guarantees that you pass the Huawei H12-211-ENUC certification exam. You can visit here for the latest Huawei certification exam practice news.